Manufacturers

RSS feed

No RSS feed added

Sparkfun FTDI Basic Breakout - 3.3V (DEV-09873)

This is a basic breakout board from SFE for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official and cloned 3.3V boards. It can also be used for general serial applications. Major difference between this board and the cable is it brings out the DTR pin rather than the RTS pin of the FTDI cable. See more info tab for further detail

More details


AU$16.50

AU$16.50 per each

BOB-00122

Availability: This product is no longer in stock


Notify me when available

Add to my wishlist

Loyalty program By buying this product you can collect up to 16 loyalty points. Your cart will total 16 points that can be converted into a voucher of AU$0.32.


Customers who bought this product also bought...

 

FTDI Basic Breakout - 3.3V Sparkfun code: DEV-09873

Description: This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.

The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is DTR. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.

There are pros and cons to the FTDI Cable vs the FTDI Basic. This board has TX and RX LEDs that allow you to actually see serial traffic on the LEDs to verify if the board is working, but this board requires a Mini-B cable. The FTDI Cable is well protected against the elements, but is large and cannot be embedded into a project as easily. The FTDI Basic uses DTR to cause a hardware reset where the FTDI cable uses the RTS signal.

This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). Our Arduino Pro and LilyPad boards use this type of connector

Documents:

No customer comments for the moment.

Only registered users can post a new comment.

Cart  

No products

Shipping AU$0.00
Total AU$0.00

Check out