Manufacturers

RSS feed

No RSS feed added

Sparkfun Logic Level converter BOB-08745

The SparkFun logic level converter (BOB-08745) is a small device that safely steps down 5V signals to 3.3V and steps up 3.3V to 5V. This level converter also works with 2.8V and 1.8V devices. Each level converter has the capability of converting 4 pins on the high side to 4 pins on the low side (2 channel bi-directional). Two inputs and two outputs are provided for each side.

More details


AU$2.15

AU$2.15 per each

BOB-00112

38 items in stock

Add to my wishlist

Loyalty program By buying this product you can collect up to 2 loyalty points. Your cart will total 2 points that can be converted into a voucher of AU$0.04.


100 quantities 75 quantities 50 quantities 25 quantities 10 quantities 5 quantities
-AU$0.32 -AU$0.30 -AU$0.27 -AU$0.24 -AU$0.21 -AU$0.11

Customers who bought this product also bought...

Manufacturer: Sparkfun Electronics

Manufacturer part number: BOB-08745

If you've ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. The SparkFun logic level converter is a small device that safely steps down 5V signals to 3.3V and steps up 3.3V to 5V. This level converter also works with 2.8V and 1.8V devices. Each level converter has the capability of converting 4 pins on the high side to 4 pins on the low side. Two inputs and two outputs are provided for each side.

Bread board friendly! Can be used with normal serial, I2C, SPI, and any other digital signal. Does not work with an analog signal.

The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'HV' pin, low voltage (2.8V for example) to 'LV', and ground from the system to the 'GND' pin.

Pins are labeled as Inputs and Outputs. These are relative to the board. A digital one going into the RXI pin on the 5V side will show up on the RXO pin on the 3.3V side as 3.3V. A digital one going into the TXI pin on the 3.3V side will show up on the TXO pin on the 5V side as 5V.

An example of it's use can be found at Digital Compass using I2C, Arduino, and Sparkfun Compass Module

Dimensions: 12.7mm x 15.2mm (0.5" x 0.6")
Documents: Schematic

No customer comments for the moment.

Only registered users can post a new comment.

Cart  

No products

Shipping AU$0.00
Total AU$0.00

Check out